Artwork Print & Cut / Razer Panthera EVO

Describes the option to order an artwork.

Insert cut

This is a choice whether it is necessary to cut the image red part.
※ Even if NO is selected, the button hole itself is cut. This is a question of whether to cut out the button inside.
If you do not need to select No, insert cuts are not included in the product.
This option is to reduce the burden on work staff.

If you select "Yes", select the worker of the button to use next.
Optimized according to the selected manufacturer.

Also, if you want to design insert cuts, please refer to the following.
https://akecon.games/a/help/article/10534

About Uploading Artwork

Upload the artwork file created using a template.
The upper limit of the file that can be uploaded is 200 MB.
Also, the corresponding file format is PSD (recommended), PNG, TIFF, PDF, JPG.
For detailed points and TIPS Check this please.

Can I open the screw holes in ○○?

This option exists only for some artwork prints.
If it is a default selection, it will remain in the initial state (manufacturer standard).
If you want to change, select "no".

About paper

Matte paper is selected as standard.
The paper specification is as follows.

Matte paper
Base: Dedicated paper thickness: 220μm surface: Matte Whiteness: 93%
High-white special paper with a solid thickness

Semi-grossed paper
Base: Special paper Thickness: 220µm Surface: Matte Whiteness: 93
Thick, high whiteness photographic paper base

※ Cautions when selecting semi-gross paper

Due to the nature of laser cutting, the semi-gloss paper may burn a little.
You can only see the slightly burnt part due to the reflection of light.
Please make sure you understand the characteristics of the product before ordering. Please note that we do not offer any refunds or returns due to burned products.

First, please dl the template you want to use.
Because it is a zip file, unzip the zip and the PSD file is included.

PHOTOSHOP to open PSD file or PhotoPea Please use it.
Opening a PSD is as follows.
 

The red frame is the overprinted part.
It is a line that is cut with a black line.

You must fill in the image to the red line to print and cut.
If it is a black line snug, please be sure to fill it until the red line will be found because it will be out because it will be a slight deviation when cut or printing.

The following example is bad example is.
 

The upper and lower are filled up to OVEPRINT
The left and right is not filled, which may cause margins to be born.

The following is the following.
 

All overprint layers are filled up to red lines.

If uploaded by PSD, save and upload it in this state.

In the case of non-PSD

※ Basically, PSD is recommended.
Basically the same as the above contents
When saving, turn off the following layers.
OVEPRINT, GUIDE (if any), Layout, remove these and turn off the border and save.
The preservation example is as follows.
 

It will be over.
Basically, please upload as much as possible in PSD format that can be easily checked at this time.