Wiring for GP2040-CE V5.6E

If you are using a normal quick cable for connection, simply point the 20-pin and 4-pin cables of a wiring harness such as Brook Fighting cable.
If you use screw terminals, please check the numbers on the board.
About USB port (hardware side)
Either the USB-B or USB-C port on the right side of the upper image can be used to connect to the hardware (PC, etc.) side.
Although the USB-C interface is used, the RP2040 operates in USB 2.0 mode for convenience.

About USB host port
The USB-A port on the left side of the upper image is for connecting USB certified devices.
By connecting in PS5 mode, etc., and using a USB dongle, the 8-minute timer problem can be avoided.
For details, please refer to the official website atConsole Compatibilityon the official website for details.

Web Config mode
Various functions can be configured in Web Config.
Please refer to the official website for more detailed information.
Here, we only explain how to access the site.

You can access the Web Config screen in one of the following ways
While holding down the Web Config button on the board, press and hold the Reset button or point the USB again.
While holding down the Option button (Start), connect the USB.

After connecting in the above way, you can access 192.168.7.1 in your web browser.
The web setup screen is available in Japanese.

The following operating systems are supported for Web Config.
  • Windows
  • Mac OS
  • Linux
  • SteamOS
  • iPadOS

About OLED

The specifications for available OLED displays are as follows
Driver IC: SSD1306, SH1106, or SH1107 
Interface: I2C Interface

Custom splash and other settings can be configured via WebConfig.

Connection Mode Switching

When connecting to a device other than a PC (Xinput), you must manually switch modes.
While holding down the desired switch button, make the USB connection.
Once you change the connection mode, the connection will be made in that mode from the next time onward.
*The above information is based on the firmware version at the time of purchase.
The button to change this mode can also be changed from Web Config.

Switching buttons for each mode:
1P(□) : PS3
2P(△) : PS5
3P(R1) : Xbox One
1K(X): Switch
2K(◯): PC (Xinput)

Boot button
PC recognizes it as a media by connecting it while holding down the Boot button.
This mode is used when updating firmware or deleting firmware using Nuke files, etc.

Reset button
Resets and reconnects the USB connection.

Web Config button
Button to switch to Web Config mode as described above.