We explain the assembly method of ZERO ONE STICKLESS [All-Button].

ZERO ONE STICKLESS [All-Button] accessories

ZERO ONE STICKLESS [All-Button] acrylic panel

Screws for ZERO ONE STICKLESS [All-Button] etc.

  1. Left photo, 4 long nuts.
    The length changes depending on the size of the side panel.
  2. Second from the left, 4 plastic feet to install on the bottom of the case.
  3. Third from the left, M3 standard screws, 15mm long screws and spacers
    used to stop PCB.
    Two screws, two PCB spacers and two nuts.

  4. Fourth from the left, M4 screws, 15mm for the top panel, 20mm for the bottom, 2 of each type, for a total of 4 screws. These are the parts that come with the case kit.

Please
refer to the parts guide of each product page
about other parts necessary for assembly.

About the assembly of ZERO ONE STICKLESS [All-Button] body



Set the countersunk screws in the mounting holes for PCB board.


Temporarily fix the screws with masking tape to prevent them from falling out as well as when you install the lever.


Turn the unit over. Put the spacer for PCB into the screw.

Set the Brook Fighting Board and fix it with the nut.
Turn the board over and return to the front side, where you will install the 24mm optional buttons, which
are 5mm thick, so we recommend using screw-on buttons as they will not
fit properly.


Top panel of 3mm thickness and M4 countersunk screws (thicker one)
Prepare the short one with 15mm length.

Place a 3mm thick top panel on the 5mm thick panel.
Once the panels are stacked, install the countersunk screws of the shorter 15mm panel in four places.
At this time, you will also attach the buttons to the 3mm top panel.
If you are installing artwork, insert it between the panels at this time before installing the screws.


Prepare the supplied long nut, the one
used in this sample will be the most versatile 45mm size.
(The length will vary depending on the side panel you choose.


Turn the panel to the back side, and attach the long nuts to the screws that you have just installed in 4 places.

Wiring

For wiring, please refer to this article "How to Wire the Akecon Original Harness for installation, and if you use
Brook Fighting Cable, please refer to here
.

Prepare the side panel and USB related parts


Prepare the side panel, 6 x 24mm buttons for the side panel, USB C to A mount jack and USB2.0 A to B right angle 50cm.


Attach the USB C to A mount jack.

After wiring, it will look like this.

Insert the side panel and connect the USB C to A mount jack to the Brook Fighting Board with a 50cm USB2.0 right angle cable.

Once you've done this, check to make sure there are no problems with operation or wiring.
If there is no problem, we will install the bottom plate 5mm on the back side.


Prepare M4 standard countersunk screws 20mm and plastic feet for the case.


After inserting the 5mm thick panel, overlap the 3mm panel and screw the plastic feet in 4 places.
When attaching the artwork, sandwich it between the clear panels and then attach the plastic feet.


Put it back on the table and it's finished, enjoy ZERO ONE STICKLESS [All-Button]!

Supplement

It is very useful as a base if you use Styrofoam bricks when assembling.
It is recommended to use a styrofoam brick as a base because it has a hole for the joystick lever and a proper height.
In Japan, you can buy them at 100 yen shops such as DAISO or home centers.